“Aqua P” Build – Part XI

“Aqua P” Build – Part XI

Before the whole guitar can be finished the grain in the mahogany must be filled. Without filling the pores in the timber would lend a rough and uneven feel to the instrument and also collect dirt and sweat. I have found the most effective way to fill grain on mahogany is with a transparent epoxy. If filling with a coloured filler it is important to make sure that the colour is a few shades darker than the natural mahogany colour.

zpoxy1

Here I use Zpoxy and spread it thinly over the mahogany working it into the grain. Once it has dried I sand back to the mahogany and repeat. Three coats is usually sufficient but that can often vary depending on the grain.

zpoxy2

I work an area and then when it is dry move on to another area to avoid tacking the filler. The aim is to get it on as thin as possible to leave as little sanding back as possible.

zpoxy3

 

zpoxy body

 

zpoxy sand

Once the filling is completed I give the whole body a thin coat of shellac to provide a base for the lacquer or french polish.

sealer.jpg

Note that whatever I do to the guitar when finishing I test first on the scrap which is visible in the picture above. If it goes wrong now mistakes are messy and difficult to put right.